WWW.TRANCETUTORIAL.COM
Z3TA+ Power Osc
Page 4
Effects Part 1
Now to add some effects and make the sound thicker and more
expressive.
22. Left Click the Effects Button to view the Effects
Page.
Look at
the Modulation Section. This section allows you to apply various modulating effects
such as phasing, flanging and chorus. These effects are good for fattening
everything up.
You use
the Mode Field to choose which kind of modulating effect to apply.
23. Set Modulation Mode to 6-Voice Chorus.
This is a
very fat chorus effect.
The Speed
Slider controls modulation rate.
24. Set Modulation Speed to 1.44Hz.
The Delay
Slider sets modulation delay time. Delay time is the time difference between
the original signal and the modulated signal.
25. Set Modulation Delay Time to 12.19ms.
The Level
Slider controls the mix between wet (modulated) and dry (source) signals.
26. Set Modulation Level to 35.9%.
Look at
the Delay Section. Delay can go a long way towards making your synth sound ‘pro’.
The Mode
Field is where you choose which type of delay to use.
27. Left Click Once
in the Mode Field and select Stereo Delay.
The Stereo
Delay algorithm is exactly that; a standard stereo delay.
The Sync
Field sets the beat division.
28. Left Click the Arrow Tab next to the Sync
Field and set Sync to 1.
The Delay
Section comes equipped with a built-in EQ unit to EQ out unwanted frequencies
in the wet signal. You may choose between various different modes using the EQ
Mode Field.
29. Left Click Once in the EQ Mode Field and select STD (ST what!?-Ed).
This is
the standard EQ mode.
It would
be nice to hear the delay. The Level Slider controls the delay mix.
30.
Increase Delay Level to 53.1%.
Now the
mix between the wet (delayed) and dry (source) signals is about equal.
The Time L
Slider sets the left delay time.
31. Set Delay Time L to
0.38s.
The Time R
Slider sets the right delay time.
32. Set Delay Time R to
0.38s.
The Feedb Slider sets delay feedback (amount of repeats).
33. Set Delay Feedback to 71.9%.
The Low
Slider controls the amount of low cut applied to the wet signal, utilizing the
aforementioned EQ mode.
34. Set Delay Lo EQ to -14.06dB.
The Mid Slider
controls the amount of mid cut applied to the wet signal.
35. Set Delay Mid EQ to -4.69dB.
The High
Slider controls the amount of high cut applied to the wet signal.
36. Set Delay Hi EQ to -2.81dB.
Copyright
owned by TTIUK - Terms and
Conditions